The FR903 is a custom gage that provides a quick and accurate flushness measurement. The flat end stylus is perfect for measuring the highest point of the fastener head for flushness after installation. The contact area of the flat stylus is generally sized to cover approximately 80% of the fastener’s head. The tripod bases listed in the table can be easily interchanged to clear the installed fastener head. This gage could be used in combination with any countersink depth or diameter gages in order to achieve greater control of the fastener installation process.
Features:
- Measuring accuracy .0001 inch (.0025mm)
- Direct contact with the stylus allows pin point selection of the protrusion measurement
- Direct reading, no calculations or charts necessary
- Accurate, repeatable and reproducible
- SPC ready via data port cable
- Ease of use with minimal training
- Gage and set block calibrated to NIST traceable standards
- Unique serial numbers on gages, set blocks and indicators
- The components of our gages are made of heat treated wear resistant tool steels and micro finished to ensure accurate and trouble free operation
Digital Indicator Features:
- LCD display with rotating bezel
- Inch/ mm mode toggle capable
- SPC data output ready via data port
- Upper and lower tolerance capable
- User selectable resolution
|
Benefits:
Physical
- Control installed head height
- Better paint adherence
- Reduce costly rework
- Eliminate panel rejection
- Reduce corrosion
Process Improvements
- Common gaging method
- Implement SPC
- Continuous process improvement
- Verify tool performance
- Control variability
- Increase customer satisfaction
|
Ordering Information:
Trulok® gages are built to your exact specifications. The size of the flat (zero) set block is determined by the size and base configuration. Please supply us with the following data:
