The FR900 gage provides a quick and accurate flushness measurement. The .060 inch (1.5 mm) flat point stylus is perfect for measuring selected areas of the fastener head for flushness. The base is fixed and it has an internal ID of .63 inch (16 mm). Used in combination with a countersink depth or a diameter gage provides the user with greater control of the fastener installation process. This versatile gage can check flushness for fasteners, welds and grooves.
Features:
- Measuring accuracy .0001 inch (.0025mm)
- Direct contact with the stylus allows pin point selection of the protrusion measurement
- Direct reading, no calculations or charts necessary
- Accurate, repeatable and reproducible
- SPC ready via data port cable
- Ease of use with minimal training
- Gage and set block calibrated to NIST traceable standards
- Unique serial numbers on gages, set blocks and indicators
- The components of our gages are made of heat treated wear resistant tool steels and micro finished to ensure accurate and trouble free operation
Digital Indicator Features:
- LCD display with rotating bezel
- Inch/ mm mode toggle capable
- SPC data output ready via data port
- Upper and lower tolerance capable
- User selectable resolution
|
Benefits:
Physical
- Control installed head height
- Better paint adherence
- Reduce costly rework
- Eliminate panel rejection
- Reduce corrosion
Process Improvements
- Common gaging method
- Implement SPC
- Continuous process improvement
- Verify tool performance
- Control variability
- Increase customer satisfaction
|
Ordering Information:
Trulok® gages are built to your exact specifications. The size of the flat (zero) set block is determined by the size and base configuration. Please supply us with the following data:
