The F1 TRULOK® mechanical gage provides a quick and accurate flushness measurement. The .060 inch (1.5mm) flat point stylus is perfect for measuring selected areas of the fastener head for flushness. The base is fixed and has an in ternal ID of .63 inch (16mm). A metric gage F1M is available with a scale between -0,50 to +0,50. Used in combination with a countersink depth or a diameter gage it provides the user with greater control of the fastener installation process. This versatile gage can check flushness for installed fasteners, welds and grooves.
Features:
- Calibrated inch scale from -.010 to +.025 with .001 inch divisions
- Calibrated metric scale from -0.50 to +.050 with .02 mm divisions
- Direct contact with the stylus allows pin point selection of the protrusion measurement
- Direct reading, measurement remains displayed until the gage is re-zeroed
- Accurate, repeatable and reproducible
- Ease of use with minimal training
- Gage and set block calibrated to NIST traceable standards
- Unique serial numbers on gages, set blocks and indicators
- F1 is the most rugged, dependable flushness gage
- Heat-treated tool steels and micro finished parts ensure accurate and trouble free operation for years to come
|
Benefits:
Physical
- Control installed head height
- Better paint adherence
- Reduce costly rework
- Eliminate panel rejection
- Reduce corrosion
Process Improvements
- Common gaging method
- Implement SPC
- Continuous process improvement
- Verify tool performance
- Control variability
- Increase customer satisfaction
|
Ordering Information:
x
Important Note:
* Please specify at time on the purchase order the desired type of base you would like to have on the gage.
